Posted On
Posted By admin

information. Refer to EEMAC Standards Publication for more information regarding applications, features and design tests. Individual EEMAC product Standards. lished by EEMAC are similar to those of UL and CSA. See our rat- ings reference sheet for details. EEMAC. The performance ratings estab- lished by IEC, known. Section Operation Requirements. There have been incidents of opposing views or assumptions around how the business of the Product Sections should be.

Author: Arashibei Nami
Country: Angola
Language: English (Spanish)
Genre: Health and Food
Published (Last): 1 October 2016
Pages: 369
PDF File Size: 3.97 Mb
ePub File Size: 6.38 Mb
ISBN: 198-1-18823-214-9
Downloads: 19746
Price: Free* [*Free Regsitration Required]
Uploader: Mauzilkree

View the Blogger Directory. Your company, a manufacturer, happens to have a large number of very competent engineers, in the power system engineering group, who can perform this work!

In a nutshell, arc flash analysis specifies what to do to ensure the safety of personnel when an arc flashes on site. Failure of the average wet. The standard color of the glaze shall be brown.

Direct etandards to such heat radiation can cause severe burn injuries. January 2, 9. I work for an electrical equipment manufacturer. Penetration of the dye into the body of the dielectric shall constitute failure of the lot to meet this standard.


Is terminology an issue for you? Not to prevent the arc fault flash itself. Arc flashes have little to do with devices.

Sampling, Inspection and Tests 9.

Technical Data NEMA / EEMAC Ratings

If more than 4 but less than 10 of the insulators standadds to meet the requirements of paragraph 4. Randomly select an independent growth rate for the. What is internal arc resistance? The entire surface shall be relatively free from imperfections. Other factors in arc flash hazards are:. There lies the only possible terminological confusion: Three insulators shall he selected at random and tested in accordance with Section 4.

Design tests on insulators of new design shall be made iii accordance with paragraphs 9. Have you struggled with arc flash and resistance? Scope 11 These standards cover spool. To that end we put switchgear through arc-fault tests. Its goal is to eemxc damage and injury. Is the terminology really so confusing?

Binational Wire and Cable Packaging Standard

This was a very good article. Essentially there is no such thing as switchgear arc flash characteristics. Failure of more than 10 insulators total from both standarss tirst and second samples shall constitute failure of the lot to meet this standard.


As you pointed out, Manufacturers cannot control the way equipment is used. Math 8 HW 50 Dilations. Dimensions and Characteristics 5.

Feb 13, 18, 19 – Design Project: Reply This was a very standardds article. Test specimens shall be selected from insulators destroyed in other tests and tested in accordance with Section 5.

“Arc Flash” vs. “Internal Arc Resistance” – A tale of two terms

Three insulators shall be selectcd at random and tested in accordance with Section 4. They require arc flash analysis.

Five insulators shall be selected at random and tested in accordance with paragraph 5. Because they are sparked by the way an individual installation is configured and operated, there are just too many variables. Although we manufacturers sometimes propose arc flash analyses as a service, they are usually performed by a competent engineer. An analysis assesses how intense an arc flash may be in a particular installation by factoring in parameters like those I listed above short-circuit current, relay settings, fault current flow, etc.